The new TruCut by CtD Pads are specially designed for bowling balls. These pads will give a longer lasting, true cut, that resists "Lane Shine", and improves consistency and bowling ball performance.
The regular 6 Pack contains the following 6 TruCut Sanding Pads:
- 1x 500 Grit
- 1x 1000 Grit
- 1x 1500 Grit
- 1x 2000 Grit
- 1x 3000 Grit
- 1x P5000D Grit
If you would like to choose your own pack, please leave us a note in the comment box.
Watch this video on how to properly sand a bowling ball:
Close up of TruCut by CtD vs Abralon:
- Longer Lasting
- Cuts True to Grit
- Reusable and Easily Cleaned
- Easier to Control When Sanding Dry or Wet
- 5 Inches in Diameter
- Open Weave Design
For Laneside Touch-ups Beforce or After Competition:
Apply pad to the surface of the bowling ball with moderate pressure using small circles. Move around the sides of the ball first and then to the top. Repeat this twice to cover the entire half of the bowling ball, then flip it over and repeat on the other half.
Apply That Purple Stuff to a CtD Power Pad and wipe the dust from the surface.
Start by spraying the TruCut Sanding Pad with So Fresh & So Clean Ball Life Extender to decrease dust and increase the longevity of your bowling ball and the TruCut Pads.
For Use with a Ball Spinner:
Spray TruCut Sanding Pad with water. Turn the spinner on low and apply the pad to the surface of the bowling ball using moderate pressure. Move back and forth from the top of the ball to the sides of the ball for 5 seconds. Flip the ball and repeat on all 4 sides for even coverage.
Write the grit numbers on the back of the pads with a permanent marker.
If used dry - hit against a hard surface to knock the dust out.
If used wet - run under water and press flat. DO NOT CRUMPLE.
TruCut Sanding Pad - 6 Pack
- Product Code::TRUCUT_6PACK
- Ex Tax: 24.33€
- Tax: 4.62€